What is a Recovery BIOS?
If a severe error such as a power failure occurs while the BIOS update is in progress, the BIOS may become
corrupted and leave the system in an unbootable condition. The Fujitsu Technology Solutions Recovery BIOS
technology allows the repair of the BIOS; a new BIOS can be flashed from a floppy disk or a USB Memory Stick
any time, thereby restoring the functionality.
The Recovery BIOS resides in its own area in the Flash EEPROM; it is well protected from corruption and
available even after a disastrous flashing attempt. If required, use the following method to recover the BIOS:
1. Turn off the computer, disconnect the A/C power cable and open the case
2. According to your type of mainboard, set jumper to: “Enable System BIOS recovery”; see table
below for the jumper settings
3. Close the chassis, reconnect the A/C cable
4. Insert a BIOS Update diskette (see section “How to update the BIOS?”) or an USB Memory Stick
and turn the computer on
5. Watch the sounds from the system speaker
The BIOS recovery was successful when you hear beeps in the sequence ”short-short-long-long-
long” and the floppy activity light turns off. The BIOS recovery may take a few minutes.
6. Turn off the computer, disconnect the AC cable and open the chassis
7. Reset the jumpers to their original position
8. Close the chassis, reconnect the A/C cable and remove the diskette or USB Memory Stick
9. Turn on the computer and enter the BIOS-Setup. (Press the <F2> key during Boot)
10. Select “Get Default Values” in the menu EXIT
11. In the menu “EXIT”, choose “Save Changes & Exit”
ftp://ftp.ts.fujitsu.com/pub/mainboard-oem-sales/Information/ProductFacts/PF_Recovery_BIOS_e.pdf
Bei deiner Ahnung aber ein NoGo und wenn da am Monitor nix mehr angezeigt wird ist das Mainboard ein Fall für die Tonne!
Lehrgeld halt und das Board ist auch nur noch sehr sehr wenig wert...
Alpha13
