Hallo Kann mir hier jemnd mitteilen, welche Baugruppe bei der Fehlermeldung defekt ist ? Vielen Dank !
Drucker, Scanner, Kombis 11.493 Themen, 46.752 Beiträge
Crusty_der_Clown WiZO1 „HP Laser Jet 4, Fehlermeldung 51“
Moin,
ich zitiere mal aus dem Servicemanual:
51 ERROR
51 PRINTER ERROR
Indicates loss of laser beam for over 2 seconds. Press
[Continue]* to clear this error. If the error persists, refer to
the “51 ERROR Message” section.
51 ERROR Message
The 51 ERROR, and the 41.2 ERROR are caused by Beam Detect
failures. If the beam detect signal is lost for more than 2 seconds
the error is posted as a 51 ERROR. The 41.2 ERROR can be cleared
by pressing [Continue] (or Go). The 51 ERROR may be cleared by
power cycling the printer.
Checks Action
1. Are all connectors on the DC
Controller properly seated?
Inspect connectors and wiring. Reseat or
replace cables if necessary.
2. Is the Laser/Scanner Assembly
Defective?
A defective Laser/Scanner Assembly can
cause a 51 ERROR by spinning the
scanning mirror at the wrong speed.
Replace the Laser/Scanner Assembly.
3. Is the DC Controller Defective? Replace the DC Controller.
4. Has the printer been moved from a
cold to a warm room?
Allow the printer to stand 6 hours until
any condensation has dissipated.
Table 7-11 51 ERROR Beam Detect Checks
Gruß
Jürgen
