Hallo,
ich wollte mal fragen ob jemand einen Tipp für mich hat wie ich die 3D beschleunigung der 4000 XT unter SuSE 8.2an bekomme.
Habe mir den powervr-Treiber besorgt und es inst. wie in der Anleitung steht.
Aber Sax2 sagt dass die 3D-Beschleunigung nicht unterstützt wird???
Also, vielleicht kann mir ja jemand helfen.
Danke schon einmal für jede Antwort
the_mic 
xtodaimand „Hercules 4000 XT unter SUSE 8.2“
nochmals ich...
meine alte XF86Config mit den kyro-treibern habe ich zum glück aufgehoben ;-)
# **********************************************************************
# Graphics device section
# **********************************************************************
# Any number of graphics device sections may be present
# Standard VGA Device:
Section "Device"
Identifier "Standard VGA"
VendorName "Unknown"
BoardName "Unknown"
# The chipset line is optional in most cases. It can be used to override
# the driver's chipset detection, and should not normally be specified.
# Chipset "generic"
# The Driver line must be present. When using run-time loadable driver
# modules, this line instructs the server to load the specified driver
# module. Even when not using loadable driver modules, this line
# indicates which driver should interpret the information in this section.
Driver "vga"
# The BusID line is used to specify which of possibly multiple devices
# this section is intended for. When this line isn't present, a device
# section can only match up with the primary video device. For PCI
# devices a line like the following could be used. This line should not
# normally be included unless there is more than one video device
# intalled.
# BusID "PCI:0:10:0"
# VideoRam 256
# Clocks 25.2 28.3
EndSection
Section "Device"
BusID "PCI:1:0:0"
Identifier "KYRO"
Driver "powervr"
BoardName "unknown"
EndSection
# **********************************************************************
# Screen sections
# **********************************************************************
# Any number of screen sections may be present. Each describes
# the configuration of a single screen. A single specific screen section
# may be specified from the X server command line with the "-screen"
# option.
Section "Screen"
Identifier "Screen 1"
Device "KYRO"
Monitor "monitor"
DefaultDepth 16
Subsection "Display"
Depth 8
Modes "1280x1024" "1024x768" "800x600" "640x480"
ViewPort 0 0
EndSubsection
Subsection "Display"
Depth 16
Modes "1024x768" "800x600" "640x480"
ViewPort 0 0
EndSubsection
Subsection "Display"
Depth 24
Modes "1280x1024" "1024x768" "800x600" "640x480"
ViewPort 0 0
EndSubsection
EndSection
