PartitionMagic meldet in meiner Partition den Fehler Nr.108. Nun bin ich natürlich nicht schlauer
als zuvor. Weiß jemand was das für ein Fehler ist ?
Archiv Hardware perfekt konfigurieren 12.949 Themen, 54.079 Beiträge
wapjoe 
(Anonym) „Fehler No. 108 auf meiner Partition“
Hab was über den Fehler gefunden: (in Englisch)
#108 Partition doesn’t end at end of cylinder
See error #105.
#105 Partition starts on wrong boundary
The hard-disk partition table contains erroneous values. PartitionMagic expects
partitions to begin and end on the correct cylinder boundaries. If they do not, the
disk may be partially corrupted. In this circumstance, if PartitionMagic were to
make any modifications it might cause the loss of data. Therefore, PartitionMagic
refuses to recognize any of the hard disk’s partitions. To resolve this problem, see
the instructions in “Resolving Partition Table Errors” on page 113.
Resolving Partition Table Errors
Partition table errors are errors in the 100 - 199 range. In most cases, you must resolve
partition table errors by creating new, error-free partition tables. The general steps are:
(1) ensure you have no viruses (see below),
(2) back up the data on the affected partitions,
(3) delete the partitions,
(4) recreate them, and
(5) restore their contents.
You may need to use
the FDISK program from a recent DOS version, as earlier versions may refuse to delete
HPFS or hidden partitions, and the OS/2 FDISK program may recognize the partition’s
corruption and refuse to modify it.
In some cases, you can resolve partition table errors manually. Run PartitionInfo to
determine the errors on your partitions. PowerQuest technical support can help resolve
partition table errors if you e-mail the PartitionInfo report to help@powerquest.com.
Refer to “Generating Diagnostic Reports with PartitionInfo” on page 87 for additional
information about PartitionInfo.
Hoffe das es hilft
wapjoe
