Hallo zusammen.
Kann mir jemand sagen, wie ich beim BJC-5500 ins Service Menue komme, um den Zähler für den Tintenfilz zu resetten. Filz wurde gesäubert und wieder eingebaut.
Danke im Voraus.
Drucker, Scanner, Kombis 11.501 Themen, 46.842 Beiträge
Crusty_der_Clown Frank1961 „Reset BJC-5500“
Moin,
nur in englischsprachiger Originalversion aus dem Servicemanual (nicht korrekturgelesen, wurde per OCR Texterkennung rauskopiert):
3.5 Service Mode
Service mode is required when replacing the waste ink absorbers, the logic board, or the
EEPROM. To prevent data being deleted in error, only select service mode when
absolutely necessary. When replacing the waste ink absorbers, logic board, or
EEPROM, also see Part 1, section 3.1, "EEPROM Data" (page 1-12) and Part 5, section 3.3,
"Notes on Replacing the Logic Board and Waste Ink Absorbers" (page 5-8).
Select service mode as follows:
1) Select BJ control mode.
2) Press and hold the MENU, CARTRIDGE, and PARKbuttons together for at least 5
seconds. The buzzer sounds to indicate that service mode has been selected.
When you are in service mode, the test print Nos. are followed by Nos. 7 to 12. Select
a No. in the same way as when selecting a test print.
Table 3-12 Service Mode
No. Service mode
7 Clear waste ink counter only.
8 Clear destination country ID only (select 120V specifications)
9 Clear destination country ID only (select 230V specifications)
10 Clear EEPROM (all data) (set default to 120V specifications)
11 Clear EEPROM (all data) (set default to 230V specifications)
12 Dump count data in EEPROM to print
See 3.3.2, 'Test Print" for Nos. 1 to 6 .
CAUTION
If a waste ink error occurs (F/14 blinks), select service mode by pressing
the POWER button while pressing and holding the FWDADJ and REVADJ
buttons and the LF/FFbutton (all LEDs light). Next, within 3 seconds,
keep on pressing only the ONLINE button to start the printer with the
waste ink alarm (Cjl blinks), then follow the procedure above to clear the
waste ink counter. Be sure to replace the waste ink absorbers.
If you do not press the ONLINE button within 3 seconds of turning the
power on, the printer starts with a waste ink error. In this case, repeat the
procedure but press ONLINE within 3 seconds.
Gruß
Jürgen
